In the compressor system, the oil itself must be filtered on a regular
cycle so as to remove contaminants that may enter the compressor
and damage the unit. This is accomplished through the installation
of a lube oil filter, either in cartridge, or spin-on form, which
then ensures that all of the oil is cleaned as it moves through
the filter.
Filtering in 5-25 micron range (depending upon application), |
|
| it is again, the depositing
of oil-borne contaminant over time (similar to the oil-separator),
that causes the oil filter to continually increase in differential
pressure to a point at which it must be replaced in order to
continue proper filtration of the compressor oil. |
| Like all of our products, KELTEC Technolab oil filters are built
of the highest quality materials and workmanship. Specific filtration
levels are obtained through the exclusive use of high grade filter
media and consistent surface area control, obtained by a strict maintenance
of pleat quantity and depth. Leakages are prevented by the positive
seals obtained with both plastisol and epoxy encapsulation. Viton
seals are used where applications of synthetic oil are typical. |
| |
|
|
|
|
| |
|
A |
B |
C |
Part
No.
|
Capacity
(gallons/liters/min.) |
Thread
|
OD
inches / mm |
Length
inches / mm |
| KL310-017 |
2.17 / 12.00 |
3/4 - 16 |
3.15 / 80.00 |
3.66 / 93.00 |
| KL470-008 |
5.00
/ 20.00 |
3/4
- 16 |
3.15
/ 80.00 |
5.50
/ 140.00 |
| KL510-016 |
10.50 / 40.00 |
1 - 12 |
3.78 / 96.00 |
6.77 / 172.00 |
| KL320-004 |
10.50
/ 40.00 |
3/4
- 16 |
3.78
/ 96.00 |
5.50
/ 140.00 |
| KL460-009 |
10.50 / 40.00 |
1 - 12 |
3.78 / 96.00 |
5.50 / 140.00 |
| KL135-035 |
11.89 / 45.00 |
1 - 12 |
3.78 / 96.00 |
6.77 / 172.00 |
| KL440-015 |
18.50 / 70.00 |
1 - 12 |
3.78 / 96.00 |
8.30 / 210.00 |
| KL590-007 |
18.50 / 70.00 |
1 - 12 |
4.33 / 110.00 |
8.94 / 227.00 |
| KL800-020 |
47.50 / 180.00 |
1 -1/2 -16 |
5.50 / 140.00 |
11.69 / 302.00 |
|
